MCU LV/HVPSStep Check Yes No 1 Check of Photoconductor Unit attachment Re-attach Photoconductor Unit. Does the error recur when the power is turned ON? Go to Step [2]. End of procedure
...error CCU (control) and MCU (Motor Control) . Unplug washer or disconnect power. 2. Check wire harness connections to the MCU, the motor, and Central Control Unit (CCU). 3. Check the drive system for ...
Question about GHW9400SU Front Load Stacked Washer / Dryer
Error The control is unable to properly detect motor speed and the machine will shut down. If a failure occurs during high-speed spin, the door will be unlocked after 3 minutes. THIS PROBLEM IS DUE TO
error. checked wiring connection from drive motor, mcu/ccu. i also checked the resistance on the motor between pins 12 23 13 and it was 6 ohms. ran test again same error code f6. the washer won't spin
Question about GHW9400SU Front Load Stacked Washer / Dryer
error(f-6) The control is unable to properly detect motor speed and the machine will shut down. If a failure occurs during high-speed spin the door will be unlocked after 3 minutes. Potential Causes ?
...error showing up 98% of the time on high spin; 70% of time on medium & low spin. Checked conections between MCU & CCU. Should I buy a new MCU or a new washer? No do the following: Check wire ...
...Error The Central Control Unit has detected a short in the motor control unit. If a failure occurs during high-speed spin, the door will be unlocked after 3 minutes. Check wire harness connections ...
...Error The Central Control Unit has detected a short in the motor control unit. If a failure occurs during high-speed spin the door will be unlocked after 3 minutes. Potential Causes • Check wire ...
Question about GHW9100L Front Load Washer
MCU) error The Central Control Unit has detected a short in the motor control unit. If a failure occurs during high-speed spin the door will be unlocked after 3 minutes. Check wire harness connections
Question about Duet WFW9151YW 27" Front-Load Washer with 3.5 cu. ft. Capacity, 12 Wash Cycles, Cold Wash Cycle, EcoBoost/TumbleFresh Options and 3 Temperature Settings
...(MCU), and between the MCU and the Central Control Unit (CCU) • Check the Drive Motor • Check the MCU • Check the Wire Harness Replace failed component. Whirlpool Duet error f6 Google ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions