Questions & Answers for: Maytag mcu error 3

ERROR If the control is unable to properly detect motor speed, the machine shuts down. If a failure occurs during high-speed spin, the door unlocks after 3 Minutes. Possible Causes/Procedure 1. Verify

error(f-6) The control is unable to properly detect motor speed and the machine will shut down. If a failure occurs during high-speed spin the door will be unlocked after 3 minutes. Potential Causes ?

...Error F06 in your whirlpool duet indicates that the control is unable to properly detect the motor speed and so the washer shuts down. This usually occurs during high speed spin and the door will be ...

error from the CCU (Central Control Unit) to the MCU (Motor Control Unit). All you need is some Electronics contact cleaner spray and a 1/4 inch socket to remove the top of the machine and the back of

...ERROR F06 Possible Causes / Procedure1. Verify the shipping system including shipping bolts, spacersand cables are removed.2. Unplug washer or disconnect power.3. Check wire harness connections ...

...MCU by looking for operations of the drive motor. 6. Check the drive motor for powered rotations. Read more: ...

...error between the MCU and Central Control Unit (CCU). I tested the wire harness from the MCU to the CCU, I could find nothing wrong. I tried a used CCU and still got an error but turns out it was the ...

...up The error codes F6 E1 for Maytag Maxima 6000 front load washer means that the MCU AND CCU are not communicating. You need to check the wiring and plugs to make sure they have a good

...error on maytag front load washer drum motor will not come on during any cycle F25 - If the control is unable to properly detect motor speed, the washer shuts down. If a failure occurs during ...

...MCU is damaged. Procedure for reversed polarity or mis-wire 1. Clear error code. 2. Unplug washer or disconnect power. 3. Check the white wire on the RFI filter to ensure correct polarity.White wire ...