...mazda 626 tdc for crank and i seem to remember the cam timing marks are on the back of the cam,remove the rocker cover to check if iam right ,but look front bearing cap and beck one in case its the ...
...mazda MPV v6 ,2.5 I am putting in timing chain and need to set cam and crank do you know the marks? complex job chains have coloured links to line up with gears and a set number of links between ...
Mazda 323 , with a 2.0 lt engine, and also no v6 was ever installed in a 323, now if you have the original engine that will be a 4 cylinder 1.6 liter timing mark on the crank and cam is at 12 o'clok.,
...mazda 323 1994 v6 wont start it cranks over no spark run fault codes and look for cam/ crank position sensors faults. check that the cam shaft is turning ( broken timing belt/chain). Check that the ...
timing is off and it wont start cant find timming marks try this link Mazda 1600 twin cam require position of timing marks on cam pullies
...a cam seal on a 1996 Mazda MPV How do I replace the cam seal on driver side? You have to pull the Timing Belt off in order to change it and make sure you mark the CAM before you remove the ...
...mazda 4 cyl engine there are two different size cam gears not possible to have two different size gears on the cams . I take it that it is a twin overhead cam to have 2 cam gears and both have to be ...
Question about Ignition Coil Mazda Miata 91 Parts Car Auto 1991 Gn10047
Mazda MPV, with the crank at TDC where should the cam mark's be. (It's a dual overhead cam eng) A Chiltons Manual will tell you, and post pictures to boot. There are other books, too, but Chiltons has
Question about Ignition Coil Mazda Miata 91 Parts Car Auto 1991 Gn10047
cam timing marks of a mazda kl v6 engine Firstly did u remove cams,if you did,align the 2 dots at the rear of cams then tighten cam bolts, the LH side cam will be close to notch on timing cover,on the
Question about Ignition Coil Mazda Miata 91 Parts Car Auto 1991 Gn10047
...Mazda FE- DOHC 16v 2.0i which mark on the cam pulley should go on the cam pin. Dennis The timing mark on the cam pulley should line up with the cam pin at the 12 o'clock position for proper
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions