Questions & Answers for: maytag microwave panel loose

...Maytag 4205 over the range microwave It was working fine, until it wasn't. No power, no display. I have confirmed power to the socket. I'm hoping that there is a fuse I can access if I drop the ...

...panel or connection, but I would say you have a bad magnetron, the magnetron is mounted loosely, or the RF gasket (mesh washer) on the magnetron is missing, loose or damaged. I would contact MayTag ...

...microwave just stopped heating-- everything else on it runs (i.e. lights, turntable, whirring noise) but the food does not heat at all no matter what heating method you use (manual, sensor, etc...) ...

Maytag Microwave MMV1153 My Maytag Microwave model MMV1153BA is less than 6 months old. It was working fine. When I went to heat a cup of coffee, I opened the door, the light came on. I closed the ...

Maytag Microwave MMC5000 Does not heat. Has power as evident by clock and light when opened. Enter cook time, press start, can hear relay click but not power or fan. [email protected] This is ...

Maytag microwave MMV1153AAW 2005/ When I close the door, the interior light stays on and the turntable continually rotates and does not stop even when I push the stop button. This is usually caused by

Maytag OTR Microwave oven that doesn't work. After I close the door and set the time and start, I see the time countdown, but I don't see the microwave starting. I can get the microwave to start, if I

...Maytag microwave MMV4205BAQ about 3 years ago when we remodeled our kitchen. I put a cup of water in the microwave to boil and when I touched the Start button, I heard a small POP behind the control ...

...microwave heats up fine but the blower motor does not come on right away. After a couple of minutes you can hear the motor start - stop and at the end finally works fine. rheire could be a number of ...

...Maytag over the range micowave oven. Only one button "Add 30 Seconds" works. I can heat anything using this one button but if I have to open the microwave door while it is working, I have to unplug ...