...Max and run through your receiver's speaker level setup. Any modern AV Receiver with the pre-requisite analog outputs should work. Since you have to buy a power amp for your 901 front channels anyway ...
...setup. You should read pages 42 and 96 of the 606 manual. Page 42 covers impedence settings. Check your impedence settings for your speakers. The 606 handles speakers from 4 to 16 ohms. There are two ...
...Max and run through your receivers speaker level setup. *** If you use a Tape or VCR Out you will NOT be able to SELECT the source you use for the 901 Pre-Outs for listening, or else the 901's will ...
...Max and run through your receiver's speaker level setup. Write off the Tape Out as an input if you use it to extract the Front L&R channels. DO NOT monitor it or you'll chop the 901's out of the ...
...Max and run through your receiver's speaker level setup. Write off the Tape Out as an input if you use it to extract the Front L&R channels. DO NOT monitor it or you'll chop the 901's out of the ...
...on source, TV, Audio or DVD is anything wrong? have you done the audessey setup or even changed the level calibration on your receiver? if so this would reduce the actual max volume on the
Question about TX-SR705 Receiver
MAX. The receiver controls everything just fine after you run through your level setup routine again. I was looking a the 12v triggers on both units and it looks like you only have a Zone 2 trigger so
...setup, where it use to play perfectly. What could be the problem? What sound do you get at MAX output? If it's anything like the desired program, you probably have a switch out of position somewhere. ...
Question about TX-SR705 Receiver
max level its just below comfortable (at 55 its barely audible). Have run setup several times with no noticeable change. All wires and cables are working/connected and in good condition. Also, powered
Usually answered in minutes!
269 Questions
261 Questions
161 Questions
135 Questions
85 Questions