Questions & Answers for: mastercool problems

Auto does not work right. When our Mastercool is set to Auto the fan cage motor will switch to on,off,on,off,on,off. I push the Auto button off and just run the fan. Is there something I could check ...

replacing pads i forgot how to install the pads for my mastercool How do I replace a rigid pad on my Mastercool swamp cooler? we purchased a swamp cooler 4 years ago. The first couple of years it ...

noise on mastercool my mastercool makes a noise from the squirl cage only on low, however when i remove the panel to pinpiont the problem it goes away, when there is on obstructed air it makes no ...

mastercool swamp cooler fan doesnt come on. bout 4 yrs ago had similar problem. circuit board was corroded. had board replaced. this board looks ok. can hear relays click when turm power on. ...

I have an older downdraft mastercool unit. The pads have a groove on one end. Which way do I install the pads? Groove top or bottom? In or out? Thank you, Rich groove down and toward the inside of the

Mastercool unit and going on 12 years with same motor. My Master Stat Controller (CC2000A Rev 2003) was in 2 parts. The Thermostat unit in the house and the Power Control unit in the Cooler. The power

Motor Problem - The MasterCool motor startrd to run on low all the time even when the house control is turned off, If it is turned on and on HIGH it runs for a couple of seconds then turns off then ...

What would it cost to have a mastercool unit properly blocked? it's not sitting level. Is that a problem? disconnect it from the duct via the screws on the underside. use a spirit level and screw it ...

Hello, my mastercool drains what seems to be, too often, is that normal? thats just normal condensation. if there was no dripping from your unit there would be a problem.

I need a manual for my mastercool P500A http://www.retrevo.com/support/Adobeair-P500A-Air-Conditioners-manual/id/20613ag015/t/2/Click on the download document 2.02mb .. not the big download bottom on ...