Question about Alarm Lock T2 TRILOGY® Digital Locks DL2700
...and ready to program. To program new version 12345 A1A new combo A new combo this will set a new master code, if you are only using 1 code to open the lock this should suffice. Remove power pack ...
Question about Alarm Lock T2 TRILOGY® Digital Locks DL2700
...digital lock program managers code I have the trilogy dl 2700 series digital lock, I can get the master code to react and open the door, however I can't get it to go to an access code. I put in
Question about Alarm Lock T2 TRILOGY® Digital Locks DL2700
...key and wait for 5 seconds for the lock to re-lock (listen for 1 beep and red LED). If successful, this will reset factory settings, which means the master code is now 1 2 3 4 5. If you need a ...
Question about Alarm Lock T2 TRILOGY® Digital Locks DL2700
...and green light comes on but the lock does not relock. The lock is probably in passage mode, enter master code then press A5A this should bring the lock back to normal operating
Question about Alarm Lock T2 TRILOGY® Digital Locks DL2700
how do you change the master code in the computer to match the master code on the door locks? The locks are the Alarm Lock 3000. I understand the master code in the locks must be the same as on the ...
Question about Alarm Lock T2 TRILOGY Digital Locks DL2700
Master code was changed to 54321. I have disconnected the battery and held a key to erase all codes. It only erased one code not the 12345. How do I get it back to factory default? This is the website
Question about Alarm Lock T2 TRILOGY® Digital Locks DL2700
Master code has 6 numbers (123456) book says it should only have 5 numbers. need to change master and enter a user access code. Cannot do either Trinity Keyless Biometric lock: I can't answer your ...
...wait for the six additional beeps but it does not do it. All programming is erased and the factory master code is usable. It will accept a new master code when programmed but will not accept any ...
Question about Alarm Lock T2 TRILOGY Digital Locks DL2700
I have a trilogy lock. I use only the master code. It accepts the code like it is working but you can't open the door.It stopped working and then started working again and now it quit again. Is ...
...mode. TO ENTER NEW MASTER CODE press the following keys: AL 1 AL (new code) AL (confirm new code) then press the star key to EXIT program mode hold down any key for 3 seconds test new master ...
Usually answered in minutes!
68 Questions
27 Questions