Questions & Answers for: Plymouth map sensors

...I need to also locate the Speed sensor. Thanks for the Help. The MAP sensor is on the breather hose next to the breather box,The speed sensors are pictured below.Please take time to rate this a

...map sensor. On the throttle body there are 2 sensors opposite the throttle cable. the one more towards the front is the TPS sensor (throttle position sensor) it has a 3 pin connector running into it ...

po108 and po172 P0108: MAP sensor circuit high input P0172: System too rich (bank 1) Possible repair for '108', replace the Map sensor. Clear codes and run car. If ok, the MAP sensor may have caused ...

where is the map sensor on a plymouth breeze 99.... 2.0 liter The map sensor is on the intake manifold behind the alternator. Hope this helps.

...fuel) This may be caused by M.A.P. sensor as well, so check vacuum lines and clean connections on MAP sensor first. It should be one of 2 things, Fault from MAP sensor, or faulty oxygen

has codes 14 52 and 55 will not pass smog car runs fine the hc (ppm) are901 and the co is10.27 14 = MAP sensor voltage below .16V or over 4.96V 52 = Oxygen sensor stuck at rich position 55 = End of ...

...of M.A.P. sensor. Check connector and clean it, and re-try , if that doesn't work replace the MAP

...equiptment, im going out on a limb and guessing you have one of three problems, 1)bad o2 sensor,2)map sensor, map sensor hose,or 3)if you have an egr valve, it could be leaking and tricking the o2 ...

...MAP sensor voltage and inputs from other sensors, the PCM adjusts spark advance and the air/fuel ratio. The MAP sensor is mounted to the intake manifold, near the throttle body inlet to the manifold. ...

...5.5 means it is the end of the codes. However Code 13, or 1.3 as you state............. is a MAP sensor code. These vehicles are notorious for MAP sensor Issues. First inspect the vacuum hose ...