Questions & Answers for: Chevrolet Camaro makes grinding noise

...they are to easy to fix. Basically gears(for noise),bearings(for noise and leaks), and sync's for grinding. tear it down, keep it in order, and you will see the problem. Sync's need

grinding noise when i make right turn i have a 2000 Z28 camaro that when i make right turns it makes a grinding noise from the rear end sound like rear axle bearings.

...grinding noise, not a metallic noise. The banging and clunking is most likely the differential. Lots of miles and poor maintenance can cause excessive wear (slop) in the gears. It can sometimes seem ...

rear end drive gears worn on 95 chevy camaro z 28 causes roaring;grinding noises during operation in all gears ;six speed manual Make sure it is not just a axle bearing . remove the shaft and rear ...

...grinding sound when i put the clutch in reverse That sounds more like the synchro gears are out of whack rather than the clutch being the issue. If the clutch was the issue you would hear the noise ...

...makes a grinding noise. I checked under the hood, and the generator is shaking violently, which makes me friend believe that its either my Power steering is low or my belt needs to to tighten. Just ...

...grinding sound from the rear end. we took apart the rear end expecting a bearing. there was a spacer for the spindle that had shattered and the bearing on the same side was chewed up so we replaced ...

...makes a grinding sound. Reverse is not "synchronized" forward gears are, so it does make some noise, try shifting to 2nd before engaging reverse to slow gear rotation and limit gear clash or ...

...3.8 automatic transmission shifts smoothly both forward and in reverse, but especially when going up an incline in reverse it makes a grinding noise. Is it anything to worry about? No not

When starting my 90 camaro it makes a loud grinding noise Flywheel teeth chewed up or more likely the teeth on the starter chewed up/ not engaging fully