Question about Max Cn890s Coil Nailer O`ring Parts Kit
Max 890s coil nailer does not advance nails when operated. The gun has been serviced by two different tool repair shops but never fixed.It will fire a nail,if you pull the trigger one shot at a ...
the battery is not charging? check the conecking prongs on the battery and the charger. also check the charger, make sure its charging if not check the fuss in the charger. some battery of that type ...
Question about Black Max 24v Cordless 1/2 Inch Drill / Driver
i have 2 rechargers fail with in 2 months. the green light is okay but red light fails to come on & battery charger puts out weak charge. I talk via phone to allied in calif. to parts department ...
Question about Max Cn890s Coil Nailer O`ring Parts Kit
max-CN35041 seal is obsolete -no replacement- (cn565 gun) -any other seals fit, or throw gun away? Do not throw gun away, lots of life left. Most major suppliers say that the part is no longer ...
skips Skipping could be caused by various issues including, worn piston oring, cracked lower bumper, weak or missing feed spring, weak or broken spring behind feed piston, or weak/ missing check ...
my max cn445r leaks out top cap... I have replaced all rings in piston and top of gun any ideas would be helpful at this point (Remove nails) With short piece of hose used as listening device, check ...
Question about Black Max 24v Cordless 1/2 Inch Drill / Driver
After a few months of use the chuck developed a "wobble" this proceeded to get worse and finally the chuck stopped turning. It sounds like gears are grinding against one another. Question is
Question about Black Max 24v Cordless 1/2 Inch Drill / Driver
...grinding noise. Chucks DON'T make grinding noises!!!!! The grinding noise is probably coming from the REDUCTION GEARBOX which is located behind the chuck [the shaft upon which the chuck is mounted ...
Usually answered in minutes!
317 Questions
162 Questions
122 Questions