Questions & Answers for: lumina intake manifold

1999 lumina 3.1 cam sensor do i need to remove the intake manifold to replace the cam sensor If it looks like its in the way then yes it will need dismantleing

lumina starts then stalls engine starts runs for 2 or 3 seconds then stalls and will do this over and over loose connections at coil pack or alternator,fuel not reaching fuel injectors properly,vacuum

Engine size on 1995 lumina The engine size of the 95 Chevy Lumina is 3.1 Leaking from the right lower side (passenger). probably it is your water pump Likely your lower intake manifold gasket

...lumina, upon acceleration the a/c blows somewhere but not out the vents, you can hear it blowing. When you take your foot off the gas the a/c will barely blow out the vents. The vent is controlled by ...

...lumina apv has 179k and i'd like to keep it till it dies. after driving a while the car smells hot (sweet hot) but does not show hot on temp. gauge. had one puff of white smoke...once when started. ...

...intake manifold on my 1995 chevy lumina what do i do Get a bottle of STP fuel injector cleaner and it to the gas tank. If your problem is on the manifold outside get you a can of engine brite and do ...

intake gasket, !!! 1992 Chevy Lumina Euro 3.1 V6 overheated the car now i have a leak, then battery died, replaced it , the mechanic said i need a tune up (wich i know ) and that somethings wrong with

...lumina? remove the throttle body,remove the valve cover,remove the intake manifold bolts. you SHOULD be able to GENTLY pry the intake back enough to remove the gasket. be careful as to not scratch or ...

...lumina? If it's the 3.1L then it should be on the intake manifold on the drivers side toward to the rear of it. If not then it should be on the upper intake and the firewall right in the middle. Hope ...

...Lumina 3.1 liter enne The torque specification is a 2-step process; tighten the vertical lower intake manifold bolts (the four middle ones) to 7 Nm (62 lb in). Tighten the diagonal lower intake ...