Questions & Answers for: Pontiac Bonneville low voltage

Question about 2003 Bonneville

1 Answer

...mean? could be low fuel , low coolant temp , high coolant temp , low oil pressure , low voltage , high voltage , have a mechanic put a scanner on it make sure all is normal , might have false ...

Ad

Question about 1995 Bonneville

3 Answers

voltage to it all, fuses and relays check ok now what??? can you drive your 1994 buick regal without the a/c compressor on your main drive belt. if so how? Hi there. The "low limit" switch won't close

Ad

...low voltage on cooling sensor i replaced the cooling sensor that has a two wire plug on it it's located next to the thermostat and the code is still there. is there more than one sensor and if so ...

...voltage at the battery posts--should read 12.6 volts--if not, charge the battery overnight with a low rate (4-8 amps) charger. If the battery won't charge, take it back for another unit. If the ...

2001 pontiac bonneville codes 1351 and 1371 1351--IC circuit high voltage (ignition coil control circuit) 1371--DI low resolution circuit/Too few ignition reference pulses

...of the battery it should be exact 12 volt. If the battery shows low voltage then the battery needs to be re-charged. Then check out. Thanks. you can rate this solution and show your

LOW VOLTAGE AT THE STARTER. JUMPER CABLES ARE TRICKY. IF THE WIRES INSIDE ARE TO SMALL, NO GOOD. JUMPER CABLES NEED TO HAVE STRONG CLAMPS & SHOULD BE MADE WITH AT LEAST # 4 BATTERY CABLE, ANYTHING

Question about 1997 Bonneville

1 Answer

low voltage and check gauge light I have a 2000 Pontiac Bonneville. the check gauge light came on and had a small leak in the water pump so I replaced that. noticed the alternator was smoking so ...

...LOW VOLTAGE TO VERY HIGH VOLTAGE I WOULD SUSPECT A BAD METER AS MY GAS GAUGE HASNT WORKED SINCE I BOUGHT THE CAR A FEW YEARS AGO HOWEVER WHEN THE VOLTAGE DROPS VERY LOW THE CAR GETS A MISS AND ALL ...

low signal voltage. The PCM uses the signal circuit of the fuel level sensor in order to calculate the total remaining fuel (%) in the tank. The PCM sends the fuel level percent via the class 2 serial

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...