Questions & Answers for: Chevrolet Blazer low voltage

Question about 1994 S-10 Blazer

1 Answer

...block low beams don't work, replaced dim swtch Do you know how to use a 12V test light? If so....check for voltage at one of the headlight connectors............if voltage is there...replace

Ad

Question about 1998 Blazer

1 Answer

...low beam, you should have voltage on the "tan"wire at the headlight. If you do not, go to the dimmer switch under the steering column and check the same wire. If it still has no voltage, replace the ...

Ad

Question about 1998 Blazer

1 Answer

...low voltage signal from the fuel tank pressure sensor, which converts fuel tank pressure into a voltage signal sent to the ECM. Evaporative Emission Control System Pressure Sensor Low Input indicates ...

Question about 2000 Blazer

2 Answers

...low voltage somewhere but what does it mean? chevy blazer 2000 with a 4.3 engine. also the ''security indicator'' stays on so the car won't start. I changed the battery of the transmitter because I ...

low or no voltage issue. the problem now is that the car will crank, has spark and fuel but will not fire. i have replaced fuel pump, fuel pressure regulator and tested for voltage pulses at injectors

...low voltage at the starter, But the starter can be bad or ( hung in) Turn the engine by hand to se that it will turn if you hear a loud click when you turn the engine the starter ws hung, The starter ...

...low pressure switch at accumulator with test light should have voltage on both wire with a/c on, if voltage ok there check voltage at a/c compr harness connector will have two wires going to it, only ...

Question about 1999 Blazer

2 Answers

...low input. That is located on the side of the throttle body. It is kind of round and usually black in color with two screws holding it on and a wire connector. Have the voltage checked at the wire ...

Question about 1999 Blazer

1 Answer

...Low Voltage to the Fuel Pump, I checked out of the fuse block that plugs into the main wire harness on the firewall with my test light. I am getting very good voltage into the Fuse Bolck but very low ...

...low tps voltage, mapps high voltage ignition on low voltage at idle. Idle surges sputers and stalls when driving. Replaceed mapp and tps with no improvment? Truck is surging at idle in park. When ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...