LOW position voltage is supplied through a 24K ohm resistor within the switch to the windshield wiper switch signal 2 circuit, and accessory voltage is supplied to the windshield wiper switch signal 1
...low voltage reading. checked battery ok changed alternator (faulty reading 30 amps from auto store check) also for good measure changed cap, rotor, plugs. now low voltage reading on truck and voltage ...
...low voltage) requires less fuel. A high or low voltage fault in the MAP sensor circuit should set a DTC P0107 or DTC P0108. If the MAP sensor sends an intermittent zero voltage signal to the PCM, a ...
Question about 1992 S-10 Blazer
...low tps voltage, mapps high voltage ignition on low voltage at idle. Idle surges sputers and stalls when driving. Replaceed mapp and tps with no improvment? Truck is surging at idle in park. When ...
...Low voltage could be due to a dirty sensor computer measures the burn off of the hot wire which has been contaminated by dirt or K & N air filter cleaner. The number one seller of mass air flow ...
...Low Voltage. The engine control module (ECM) monitors the high side refrigerant pressure through the A/C refrigerant pressure sensor. The ECM supplies a 5-volt reference and a low reference to the ...
...low beam supply voltage circuits illuminating the low beam headlamps. Ground for the left headlamp is provided at G101 and the right headlamp at G100. Low Beam Relay Test Ignition OFF, disconnect the ...
voltage, check the low beam fuse. Not only check the fuse, use a testlite and check voltage on the fuse circuit. With headlamp switch on and dimmer switch on low beam. See the relay that says headlamp
Question about 2001 Silverado 2500
...voltage from the low fan fuse through the cooling fan motor supply voltage circuit to the left cooling fan. The ground path for the left cooling fan is through the cooling fan s/p relay and the right ...
Question about 2001 Silverado 2500
...Voltage Low Circuit/System Description The electronic brake control module (EBCM) monitors the ignition voltage level available for system operation. A low voltage condition prevents the system from ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions