Questions & Answers for: where is the low pressure switch

...low pressure switch and has 100 lbs of pressure on low side port IF YOU HAVE 100 PSI ON LOW SIDE.YOU HAVE A EXCESSIVE AIR AND MOISTURE IN THE SYSTEM.YOU HAVE TO HAVE SYSTEM DISCHARGED AT AC SHOP OR ...

...Low pressure switch on my 92 nissan pathfinder. and how can i check to see if its bad or switch it on? The low pressure switch in an A/C system cannot be manually "switched" on or off. most A/C ...

...LOW-REVERSE PRESSURE SWITCH 1.Remove transaxle relay from connector. Turn ignition on. Install scan tool and observe low-reverse pressure switch condition. Apply battery voltage to transaxle relay ...

Low end pressure you have. The Low pressure cutoff switch will disconnect the compressor if the pressure is too low. The high end pressure switch will do the same thing for extreme pressure. Sometimes

low pressure switch and the clutch/compressor still wont turn on. I by passed the low pressure switch by putting a hot wire from the battery to the conecter off the switch and the clutch engaged right

low pressure cut-off switch. Before messing with this switch, verify what your Freon pressure is. If the pressure is low, the low pressure switch may be fine and you need to add Freon and find out why

low pressure switch or a faulty clutch. You would jumper the low pressure switch to eliminate it for a test. In most cases when the compressor clutch cycles on and off it means your freon level is low

low pressure, low temperature and will not turn on low pressure will either be gas or water. technician with a manometer can check gas inlet and manifold pressure. ensure adequate water flow from pump

low pressure. The high pressure switch is usually close to the compressor and the low pressure switch is usually by the accumulator. See if you have voltage to these switches, the high pressure should

...low pressure cycling switch? Low pressure rarely goes bad, it is always on. It works the opposite of the high pressure switch. When the pressure gets to high on the low side, the switch will cut off ...