...power source, the transformer, adapter, wall wart, or whatever you wish to call it, goes above the rated values. No higher or lower V or A should make it into the device in order for it to operate ...
...while scanning Issue with Lens Correction Reading... Due To Low Voltage On Logic Board... Remaining defect On Voltage Regulation ...Please Check Power Supply If it Hot Also Check Cable Connection
Question about Scanjet 5400c Flatbed Scanner
...Low power AC power module (Wall Mount Type) - 100-120VAC, 60Hz - Detachable power cord not needed (USA, Canada) - NOTE: Use a High Power AC Power Module if an Automatic Document Feeder (ADF) is ...
...of inactivity (about 14 minutes), the scanner reduces to a low-power mode. If you need to turn off the scanner completely, disconnect it from the power source (electrical outlet or surge
Usually answered in minutes!
244 Questions
109 Questions
80 Questions
73 Questions
80 Questions