Questions & Answers for: Coleman low idle

idle what voltages are you reading at the 120VAC & the 240VAC outlets - from HOT to NEUTRAL only? Low - High - Sporadic - what? Be precise here - very important! If you increase the Genset speed up to

...low side 132 volt. what causes this problem...?jn Your RPM's are too high. There is no voltage regulator in coleman generators (generator is actually made by generac) and is 100% dependent on engine ...

...idle solenoid does not work when you throw the switch to auto. Switch is good, replaced the solenoid, still does not work. Any ideas? Generator runs fine at full speed and puts out 120/240 volt and ...

...low rpm. Will not run at a steady speed. Governor keeps moving and engine surges. This is with no load. I have checked fuel line and carburettor for blockages but still the same problem. Starts ...

LOW TO NO VOLTAGE POWERMATE 2250 new one, make sure it runs about 1800 rpm and not idle. old ones can be that the capacitor not working any more measure capacitor or try other one. just to try the ...

...Meaning it fluctuates between high idle and low. It doesn't matter if I have the hose engaged to vary the load. Any thoughts? sounds like the air filter may be blocked or the carb has a dirty jet in ...

idle for about 30 minutes, it kicked on (fan and compressor) for about 10 seconds then shut down. Now it will not come back on at all. Could the termostat be the problem? If not, what? it could be the

low idle when there is load on the generator it has idle control. I could not understand, it doesn't go in low idle when load is connected or no? It should go to low speed idle with load under 20 - 30