Questions & Answers for: losing rpm

1995 toyota camry. loses rpm and dies while idling 1995 Toyota Camry LE . loses rpm and dies while idling Bad fuel pump or clogged filter. Limited info so I can't do much more. Check the catlytic ...

Ad

losing power As I'm driving my '94 4.0L 4WD Explorer down the highway, it vehicle will start to lose power, and lose rpm's for a few moments, I slowly pump the gas and the rpm's return to normal. This

Ad

losing speed, do you lose RPM? This is important. 1- If you don't lose RPM then you have a problem with your torque converter. 2- If you lose RPM then you have a problem with fuel air mixture and this

98 Jetta loses power at 20MPH...2-3k RPM 98 Jetta loses power at 20MPH...Car idles fine and in neutral will rev all the way up to 6k RPM with no issues. Driving in any gear over about 2200 RPM acts ...

The car starts jerking & loses RPMs while driving on highway when going uphill or picking up speed. Also, loses RPM while sitting in park on certain heat/ac settings. Check engine light came on ...

1999 Chevy Tahoe 5.7L starts lurching, jerking loses power and engine rpm will not go above 2000. Turn off engine let set for couple of minutes and it starts and runs fine. May repeat, but may not fo ...

Rav4, 2003 model, loses power when climbing mountain, only 2000 rpm is reached Rav4 , 2003 model, loses power when climbing mountain, only 2000 rpm is reached Possible low fuel pressure or restricted ...

Question about 2009 Trail Touring DLX

1 Answer

...Losing RPM, then you are losing Compression. Best thing to do is look at the Compression of the Engine and if the Compression is LOWER on one Cylinder (Normally the PTO SIDE) then you are going to be ...

Question about 2005 TrailBlazer

1 Answer

lose 200 rpm while driving why i lose 200 rpm while driving ? cleaned throttle body and plugs. 2005 trailblazer with 205,000 miles Any trouble codes? Sometimes the O2 sensor affects power and doesn't ...

...losing rpm. If I shut welder off and 250 idles for awhile it runs great for a couple minutes then same thing. The Miller 212 has a 60% duty cycle. So for every ten minutes of welding the machine is ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...