Questions & Answers for: Janome loose stitching

stitching is loose. Any suggestions. I have tried cleaning, changing bobbin thread, new needle, changed tension... Thanks! test it out on 2 pieces of material by rotating the wheele by hand. pay close

...thank you ever tried adjusting the thread tension control? clean if possible tighen it more, loose tension adjustment causes loose stitch and tangling of the thread. Looping thread underneath ...

...loose so that the stitching doesn't hold. It's very possible the bobbin is in upside down and the thread is coming out of the lower tension. Pull on the thread and the bobbin should turn counter ...

...the foot down, the tension control closes and the thread cannot enter as it should You then get loose stitches because the top thread and bobbin thread cannot make a proper stitch and the tension ...

...The top thread then cannot form a proper stitch with the bobbin thread. If I forget to have the presser foot up when I thread, then I get loose stitching on top and loopy stitches on the

...stitching is very loose- I can actually pull on the end and the entire stitching just slides out. How do I fix this? try adjusting the top thread tension and see if that helps the loose stitches also ...

...of the fabric? This is an indication that either the bottom tension is too tight or the top is too loose. try tightening the top tension 1 number at a time till it looks

upper thread has a loose stitch once in a while my machine sews along just fine then once in a while there is a loose top stitch, then it continues just fine. The bobbin thread is good. check that ...

...setting is auto but bottom zig-zig is half bobbin color half top thread The upper tension is too loose. The two threads should meet in the middle of the fabric for the tension to be correct.

Having issues with my Janome 6500P with stitches since I had service stitches are loose on top of fabric on Janome 6500 and bottoms stitch has loops Sounds like a threading issue.
Be sure to ...