...bottom (bobbin) side was a mess. I was using the stretch stitch, so I changed to a straight and with the same tension, top looked good but there was no tension on the bobbin. I tried increasing and ...
Question about 15516 Mechanical Sewing Machine
...loops bottom stitching Kenmore 15516 is making random loops and I am not sure why. But it looks like hell =( What should I do? Sounds like you are getting some skipped stitches. Have you tried ...
...stitch. I have a 1980's era model 1690 Sears Kenmore March 12, 2009 kenmore 385.17922 i have started using my machine again (after several years) and am doing patchwork.. all has been fine, and ...
...the top thread is too loose. Think of 2 little elves playing tug of war in your machine, one on toip and one underneath. If you have loops on bottom, the top needs to pull harder (tighten top
...Loops on the bottom, problem is on the top. Loops on the top, problem is on the bottom. This is what you should try.. First of all, unthread the machine and start over. Just before threading the ...
Question about 15516 Mechanical Sewing Machine
Kenmore Sewing Machine Drop-in Bobbin Tension Adjusting Problems I have a one-year old Kenmore model 18221 that I have used three times. The upper thread is loose and the bottom thread seems ok. I ...
I can't get the tension on my sewing machine adjusted correctly. Right now the upper tension is turned as high as it will go and I've loosened the lower tension but I still have the upper thread ...
stitch the bur may be at the side. If this is not it then your tension spring may not be in the right slot. There are steps to take. Change the needle no matter if you think it is a good one. Re tread
Question about 19110 Computerized Sewing Machine
...bottom. I've changed the tension up and down and I still have the loops. I've also changed the fabric and the loops are still there. What else can I try? Check the manual again and make sure you have ...
Question about 19110 Computerized Sewing Machine
bottom (five black machine screws) {place screws in a tunafish can so they don't get lost}, (4) Set/Keep the Stitch-Width set to maximum, "12", (5) Set/Keep stitch selection to simple Straight stitch"
Usually answered in minutes!
126 Questions
125 Questions
111 Questions
69 Questions