...harness adaptor. you wire your stereo to this adaptor then you simply plug it into the wiring loom. no damage to the loom so if you ever need to reinstall the standard stereo its just an unplug ...
...that goes from the back of the engine up the right side then under the batt. It is covered by wire loom. Cut in to it and see if there is vac. If not check to see the switch works. If there is then ...
...wire connection for the turn signal/ wiper control arm1997 gmc jimmy if you check/follow the wire loom from the switch/stalk it will route underneath lower dash alongside steer column then normally ...
...the wiring on the side of tank going to the top of the tank to fuelpump, remove any tape or wire loom to look at the wiring i think you may find a bad wire in those wires and also check the groung ...
Question about 2000 Jimmy
...Check the wiring along the frame rail on the driver's side just behind the driver door. In the loom there is a connector the sometimes goes awry and stops the flow of power to the pump. Other ...
...truck brakes good ABS computer is receiving erroneous signals into the ABS computer. Wiring loom connections need checking. Disconnect, reconnect wiring looms around engine compartment
Usually answered in minutes!
1,363 Questions
1,123 Questions
1,127 Questions
1,104 Questions
838 Questions