Questions & Answers for: Hyundai loom

gauges not working after the car had an accident on the left side ,the wire loom was cut between the chassis and the panel. we fix the wire loom now the car start and run well but ,no check engine ,no

...work, bulb is good plug from wiring harnest is good. hi fred the earth wire from the plug wiring loom, to the body may need cleaning, follow it back to find out where it earths.take out screw and ...

with abs system? as fault had not occured on ours ? apparently there had been a fault with the wire loom to pump particularly the earh cable deteriating ? so this loom had to be inspected and replaced

...fuse doesn't blow. What would cause this and how do I fix it. Thanks Check the wiring on the hatch loom,from the loom flexing the wiring inside breaks and shorts out ,just split the rubber cover and ...

...7 Black L/H Tail & No, Plate Lights I found the easiest way to locate the correct wires in the loom is to turn on the lights required and use a circuit tester and splice into the main loom where ...

recently i've bought a hyundai elantra gl who burned in the inside,i bought a wiring harness(loom) from a scrapyard(elantra gls) can you please tell me where to find the wiring diagram for the gl as ...

The high mounted stop light comes on when the headlights are on.Also the license plate lights come on during the day when I apply the brakes sounds like the wiring loom is damaged somewhere

...connector (check across connector terminal) if no reading, there is an open wire in circuit. trace loom as far back as possible, may be easier to remove seat. most often it will be at the point loom ...

I have a 2012 Hyundai ix35& have fitted a towbar wiring loom. I have a 2012 Hyundai ix35 & have fitted a towbar & wiring loom. The reversing sensors continually beep when the trailer is connected & ...

...the problem? you need to make sure all vacuum lines are on and at the correct place also check the loom and all sensor connections plus the plug ...