Questions & Answers for: lock removal

Question about 1989 Celebrity

1 Answer

...removal. Remove switch retaining screws and pull switch up from column, guiding wire harness through column. Reverse procedure to install. Remove turn signal switch as outlined under TURN SIGNAL ...

Ad

rear anti-lock brake sensor before removal. Remove the rear anti-lock brake sensor. Remove the anti-lock brake sensor bolt. Remove the anti-lock brake sensor. To install, reverse the removal procedure

Ad

...lock, reverse the removal procedures. Tighten the lock retaining screw to 22 inch lbs., the turn signal switch screws to 59 inch lbs. and turn the turn signal lever screw to 53 inch lbs. As part of ...

Question about 1991 Corolla

1 Answer

...lock assembly Toyota Corolla 1988-1997 Repair Guide Door Locks - REMOVAL & INSTALLATION (see Figure 1) Disconnect the negative battery cable. Remove the door panel and watershield. Remove the ...

...Lock Cylinder Removal for gmc yukon 1996 When carrying a live inflator module, make sure that the bag and trim cover are pointed away from you. Never carry the inflator module by the wires or ...

my ignition is locked and will not turn. i am trying to replace the ignition but am having trouble figuring out how to remove it. do u have to take the steering wheel off and if so wont that mess up ...

Question about 1995 F150 Styleside Regular Cab

2 Answers

...lock, reverse the removal procedures. Tighten the lock retaining screw to 22 inch lbs., the turn signal switch screws to 59 inch lbs. and turn the turn signal lever screw to 53 inch lbs. As part of ...

Question about 1995 F150 Styleside Regular Cab

1 Answer

...Lock Cylinder Removal & Installation To Remove: Disconnect the negative cable from the battery. Disable the supplemental inflatable restraint (SIR) system. Remove the steering column trim covers. ...

...Lock Systems Power Door Locks - Removal & Installation Door Lock Switch Door Lock Diagnosis & Testing Visually inspect the following: Misaligned door(s), hood or luggage compartment lid Door ...

...Lock lever plate removal Unfasten the 2 retaining screws and lift the lock lever guide plate to expose the lock cylinder release hole. Insert the key and place the lock cylinder in the LOCK position. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...