Question about Kenmore Washing Machines
the motor is running but it is not moving, fills with water and drains ok. Hi, this motor has faulty windings, causing it to lock up and not rotate the drum/basket. replace this motor asap if possible
lock most machines you have to wait 2 mins for it to open ,unless it has a cable on it then it has a **** switch witch goes to the moter or pulley whitch spots the door opening when the drum is moving
Question about 24032\24036 Top Load Washer
...drum after I rung out the clothes that were in there. On this washer, the dl code indicates a failed lid lock mechanism. Pressing pause/cancel should reset the controls. You may have to unplug the ...
...drum locked for safety. How can I remove that, its a front load LG washing machine hi. the locks on LG machines are normally 2 or 3 long bolts on the rear of the machine screwed into the back of the ...
Question about ATF6000ES Front Load Washer
...washing machine i didnt puthe bolts in back in it now makes a small noise while spining it is a frigidiare front load 2 years old moved it over 300 miles without the bolts in the back Possible that ...
...moving it? Make sure that the drum is locked and if possible to tuck in thermocole or sponge so that the drum will not move along. also make sure the panel and door glass is protected, Tape with ...
...to lock the drums and make sure that the motor and drum does not move too much during the transit as it can cause alignment issues. Make sure that the drum is also transported in the correct
Question about Bravos MTW6600T Top Load Washer
...lock when stopped, if you mean there is excess movement on the inner drum then you can check this by holding your hands at opposite sides of the drums just inside the door opening, locate the outer ...
Question about HAV2360A Top Load Washer
...drum case. Single belt under machine appears to be in good condition. Agitator teeth (both sides) intact. Using locking pliers, cannot move center column. Transmission won't wiggle when handled from ...
Question about HAV2360A Top Load Washer
...Washing Machine. Tub locked up won't move? Question edited for clarity and toss in some CAPS. Remove the back. Remove the belt and see if the motor spins. Check the drum bearings aren't seized. Check ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions