Questions & Answers for: lights motion sensor

...motion sensor) Try turning the switch on and off and back on again this usually will bypass the motion detector. when you are finished you can turn the switch off for a few seconds and back on and it ...

lights they are on all day long, do not turn off usually motion sensor led lamp is a little different from general led lamp. the work condition will shift from general lighting to motion sensor light.

...lights on fully, but then after a few times it goes back to only partially lighting on auto. is it the switch? thanks, cs many motion sensor do not work with fluro tubes as stated on the fitting ...

...lights and the motion box. 1 black wire and one white per light but the middle has 1 black, 1 white and 1 red. We are hooking it to the porch light and dont know what the red wire goes to? You are ...

...motion sensor switch to a standard switch The motion sensor switch has 3 cables: neutral, hot, load. And, the cable to the light has only 2: white and black. What do I connect these 3 cables to 2 ...

...has adjustment dials. Motion sensor that lights in day has probably gone bad. Occupancy switch and motion sensor wire the same: http://waterheatertimer.org/How-to-wire-occupancy-switch.html Gene ...

...ON Usually when a motion sensor light blinks LED or otherwise it means that the motion sensor is shot. The light itself is most likely good and for whatever reason you got a bad sensor upon

...motion lights are positioned and set according to your needs. Step 1. Move the sensor from "Operational" to "Test" mode. This switch is located on the bottom of the sensor and turns the light off ...

...Motion sensor lights are typically designed to conserve energy by only activating when motion is detected, providing illumination when needed. Keeping the light on permanently may result in increased ...

...Motion Sensor The clock is equipped with a motion sensor that will detect movement in front of the clock and activate the sound and motion sensors. To disable the motion sensor, push and hold the ...