Questions & Answers for: Ford Ranger take a light reading

Question about 1991 Ranger Supercab

2 Answers

1991 ford ranger battery light My battery light just started coming on but then goes out. I have a new alternator and a 1 year old battery. why is it coming on. bad battery module for the light or a ...

Ad

Question about 2003 Ranger Regular Cab

1 Answer

light will come on with the bad reading. I need help to figure this out. When the gauge reads good the check eng light will go out until the next time the gauge goes wrong. CHECK ENGINE LIGHT ON READS

Ad

Question about 1999 Ranger SuperCab

2 Answers

...light? U can reset it with a code reader or scanner at the diagnostic connector under the dash or u can disconnect the negative battery cable for 3 minutes Do you have a scanner? if you do just hook ...

Question about 1995 Ranger Supercab

1 Answer

engine light comes on and truck ideals rough if it's the yellow, chck engine light. go to autozone & get the DTC codes read out for free. Then report codes here.

All exterior lights work but not the headlights I would try the fuse panel, usually the headlights have their own fuse, if it isn't blown headlight bulbs then take off the plug to the rear of the ...

Question about 1998 Ranger SuperCab

1 Answer

my 4x4 light is blinking the warning lights that read 4x4 hi and low would blink several times stop then start doing it again in some sort of patern. sounds like your switch is burned out, for the ...

Question about 1999 Ranger SuperCab

1 Answer

air bag light flashing on 1999 ford ranger can i disconnect the fuse for the air bag without any problems well, if your air bag light is flashing then your system is already disabled. You have no ...

Question about 1996 Ranger SuperCab

1 Answer

...light flashing. Stick shift and engine seem to be shaking upon acceleration. Could this be oil pump? If your oil pressure gauge is reading normal I wouldn't think so. You need to get your codes read ...

Question about 2002 Ranger Regular Cab

1 Answer

sometimes (like now)my rpm gauge jumps and wont read right and when this happens the check engine light comes on but when the gauge reads right the light goes off. this on a 94 ford ranger 2.3l ...

...the 2.3L are the same for each engine with the light the gauge senders are different this could be the problem wrong sender installed and its not reading pressure because it can't? good luck ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...