not getting a reading using obd2 ford explorer 2001 check engine light came on not over heating Go to Autozone or a parts store that will read your codes for free ,and go from there.
...withot a code reader. My old dodge van needed to turn key on 3 times without start to activate dash light flashing of codes. A jumper wire in a connector on my buicks and my camry caused dash light ...
I have a 2002 explorer tail lights and dash lights not working anyone know which fuse it is or number fuse it is? This is clearly labelled either as accessories or tail lights or dashboard lights. But
my overdrive light keeps blinking in a 1999 ford explorer You have a transmission code set in the computer. Most off-the-shelf code scanners won't read them. Have your dealer read the code.
...light ... set it up for amps ... there should be some reading ... remove the fuses one at a time, until the meeter reads zero amps. When it gets to zero, you are almost home. Explore that circuit to ...
...empty. Is the problem in the gauge or sender? If it was the sender, I would expect the low fuel light to be
light flashes 4 times. book says flash steady or not at all, good/bad. have swapped switch and controler no change. tested all ckts motor reads 1.3 ohm, clutch reads 5 ohm, speed sensor is 272 ohm and
I have a 2006 Ford Explorer. The wrench light (powertrain) comes on periodically, and the truck will no go beyond 40 miles for 3-4 minutes. What is the porblem when it's on go to autozone & have ...
99 expedtion abs light comes on sometimes goes away,now flasing OD light but goes awy When the ABS light comes on the module has detected a fault with the ABS, stored a code and turned on the light. ...
98 explorer no tail lights or dash lights My daughters 98 ford explorer's tail lights and interior lights stopped working a couple of nights ago. Now she's have steering issues and other issues as ...
Usually answered in minutes!
2,998 Questions
2,307 Questions
2,248 Questions
2,302 Questions
1,513 Questions
