Question about DR-5020 Path-Through Scanner
...tray through a bevel gear. Incase the palstic gear is damaged, it maynot lift the tray. U may need to change the gear. Even if the tray is overloaded, the tray will not lift. S. Mohan, Chennai, ...
97 suburban only shifts out of 1st gear when lifting the accelerator, shifts into other gears ok, when you try to go into passing gear it goes into neutral when lifting accelerator ot goes back into ...
Question about Aficio MP 161 Black and White Copier
...gear drive is located in the paper tray lift motor assembly. The gears teeth strip away with wear and tear and can no longer lift the tray to feed paper. Replace this assembly and not just the
...the gear lever so it will move over further so as to select reverse? or a lift up circular boss on gear lever itself that has to be lifted then reverse position can be selected ? hope this helps
...gear? I am living in Malaysia but can pick things up from the UK. Regards Ian My Sony CDX-636 has a mechanisim to lift and lower the CD reading carriage. It consists of a small motor and two nylon ...
...of noise is coming from the printer..please help... In this problem , first check the front side head lift gear and gear belt. solution : Gear or gear belt may be broken. by LAKSHMI KANTH,
...gear that should spin when you try to lift the helicopter. Check both big gears if they rotate/spins. Usually the problem is the small gear on the motor shaft that is not aligned to that big gear. ...
Question about Wheelwriter 6 Typewriter
...lift at all see if the black gear on the R. side of the printer will move, if not w3iggle it and it should free up they get tooth for tooth with the motor gear. If it only lifts partually ...
...side of printer. Also verify if the GEAR LIFT Z64 is intact by opening the gearbox(the big one from the gears from the right side of paper cassette). This gear is cracked in most cases. Replace
Question about WorkCentre C2424DN All-In-One Laser Printer
gear on the rear of the tray, turn it with your hand and the paper should lift. If that doesn't work, check for broken lifting gears on the tray. Alternately if the trays don't have lift gears then if
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions