Questions & Answers for: lid switch avanti machine

...lid switch Test the timer control Test the centrifugal switch Test the water level switch Inspect the motor coupler Inspect the drive belt (belt drive only) Inspect under the washer for soot (clutch) ...

...is only a forum to discuss how you can fix the issue. if the washer will not spin the the top lid switch may be damaged or not being pushed in far enough. put it in spin and push on the switch ...

...lid switch, you must check it out with a ohm meter, if the switch quits you will lose power to the motor. Things can get caught between the tanks as well, this machine is bad for the center bearing ...

...SWITCH THAT THE LID MAKES CONTACT WITH IF THIS SWITCH IS NOT WORKING THE WASHER WILL NOT SPINYOU SHOULD SEE A PIN ON THE LID THAT WILL GO INTO A HOLE ON THE TOP OF THE WASHER ,WITH THE LID OPEN PUSH ...

...lid switch is not being engaged .remove rear top cover .2 phillips screws .3 snap clips use flat blade screw driver to pop cover .look at rear of lid (door) right side plastic arm part of lid snaped ...

my washer washes but doesnt drain or spin it works to wash on cycles but dont drain or it doesnt work on spin . Check the lid switch, it is located on the top of machine,

...check lid..either the lid switch is bad or the lid switch actuator which is made into top...when in final spin push down on the right hand top part of lid,,,if it starts replace part needed,,,good ...

Avanti lid broken plastic tab that operates lid switch broke off Please check this link: door lid

...lid, or the washing machine will buzz during wash and spin cycle. In the event the clothing loaded becomes unbalanced, the safety switch will be ... 56 pages Avanti RV Appliances Instruction Manual ...

/ lid switch? Give me the model number of the washer please? https://www.google.com/search?q=Avanti+Washer%2C+Cover+Switch I don't see this very often! https://www.google.com/search?q=Z-STW20DCOVER1 .