Questions & Answers for: Honda lean mixture

...when in idle or stop and go. Help me. Would 5-30 oil cause this. Air mixture sensor is bad. It is the sensor for the gas mixture is saying it is to lean. No oil will not cause this type of ...

...mixture is too lean in gas. When you activate the choke it 'chokes' the engine of air. This is why on a really cold day the choke must be used to start the bike or to pull fuel through on a morning. ...

...should be one adjusting screw normally it is a flat head screw driver with a spring around it adjust in to lean fuel mixture and out to enrich fuel mixture should be located near bottom of ...

...Will a carb adjustment help? seems to rich, thus the popping sound, try leaning the low speed mixture De-cell popping is usually caused by a lean condition. Sounds like you could use a Dynojet

...to be eithe too rich or too lean. not sure, can you help? to adjust the mixture will be a screw on the carb fiddle with this screw till it runs perfect this is to adjust the richeness and ...

...mixture is Lean as opposed to rich. Adjust the air/fuel mixture screw clockwise in quarter turns until the idle normalizes. This screw can be found inbetween the carb and air filter. It should be a ...

...choke and there has been a recent clean and/or rebuild. It would be a good idea to check the fuel mixture screw setting. It sounds like it is running a fuel/air mix that is too thin, (lean

...lean. How do i adjust the air/fuel mixture? you have a vacuum leak some where take a can of brake clean and spray a little on the vacuum hoses and if the idle goes up then that is where the leak ...

...brown. lean will cause rough idle, and popping on deceleration. resolve = clean idle jet, circuit, and set mixture screw properly. A job like this should really be left to a professional on that

...mixture screw (air/fuel) is too far in, it will cause it to run lean/hot. The high idle is also just an adjustment often cured when you get the air/fuel mixture set correctly. Back the mixture screw ...