Questions & Answers for: lean condition

...lean condition. if the bike has a stock exhaust and air cleaner setup. most likely the pilot jet or main or both jets may have developed a builup. this is very very common. for this will produce the ...

...lean condition can be caused by too low pressure to the fuel injectors causing a lean condition where there is not enough gas being supplied to the combustion chambers. It can be caused by a faulty ...

. P0134 indicates no activity from sensor 1 on bank 1. You could have a bad O2 sensor or an actual lean condition. Possible causes of a lean condition include a restricted fuel filter on a vacuum leak

...lean condition could be present during high fuel demand due to a fuel pump that does not pump enough fuel.Review the Failure Records with a scan tool. If an intermittent condition is suspected, refer ...

...on bank 2 and p0171 is a lean running condition on bank 1. the lean running conditions could be O2 sensors, lean condition caused by bad fuel pressure, dirty injectors, bad MAF sensor, vacuum

lean condition on Bank 2. It could be an actual lean condition such as a vacuum leak that is causing it. If you have a scanner, watch the B2S1 data or the fuel trim data and introduce a rich condition

...lean condition , vacuum leak , low fuel pressure , fuel filter plugged partially , mass air flow sensor . If the misfire is random, check for the following conditions: ?€¢ System Grounds: Ensure all ...

lean condition, FT values will be above 0 percent. If the O2S indicate a rich condition, FT values will be below 0 percent. Short term FT values change rapidly in response to the heated oxygen sensor

...lean condition. Things that can cause a lean condition? Vacuum leak (bad hose, intake gasket, etc) Bad or dirty/clogged fuel injector egr valve not seating A bad sensor could cause this, but far more ...

...lean condition detected by the Engine Control Module (ECM). A lean condition will be created if there is too much air, and not enough fuel, in the air fuel ratio ...