...repair? Thanx Jake If ya can get the parts easily then it's NOT too hard to replace the "Back light" there isn't too much inside these monitors, generally there are 3 main parts the LCD and it's ...
...backlight may be going. if color is reddish or pinkish tinge. backlight is part of lcd glass itself, can be repaired, but not many shops repair them. can also buy replacement lcd glass for $100 ro
Question about MultiSync LCD4010-BK TFT 40" Flat panel Monitor
...repair and was told without schematic would be nearly impossible to replicate the power Output. Finally this one shop was able to replace the burned out components and it seem to work at the store. ...
Question about MultiSync LCD1700V 17" Flat Panel LCD Monitor
...factory today 06-01-12 This model the NEC LCD V1700v was first manufactured in Nov. 1999. As stated by factory after 12 years they no longer service or have parts to repair after Nov. 2011. GOOD ...
Question about MultiSync LCD1700V 17" Flat Panel LCD Monitor
...lcd monitor blinks off and on This monitor is going into the protection mode due to a component failure. The unit should be sent or taken in to a service center for testing and repair. The NEC ...
...LCD backlight and it could be the inverter that supplies high voltage to the CCFL lamp or it is the CCLF lamp is nearly burnt out or burnt out, most likely this is the case. The inverter can be ...
Question about MultiSync LCD2170NX-BK - flat panel display - TFT - 21.3" 21 inch Monitor
...lcd screen, the sony repair centre said they cannot fix it within the warranty. Is there any other way i can fix this? Could be a stuck pixel ... Found this on wiki - includes a video: ...
...lcd inverter inside the monitor is going bad. You can take it in to a repair shop and see if they can fix it but with the labor and parts it might be cheaper to go out and buy a new monitor for cheap ...
Hi, I have NEC multisync Lcd 2010x. got backlight problem. how to repair? asdas
LCD panel might be defective beyond repair. Youn can check your color levels. SOmetimes one will drop to zero for no reason. Try running your finger (pushing lightly on the LCD) around the edge of the
Usually answered in minutes!
23 Questions
21 Questions
17 Questions
13 Questions
11 Questions