...switch or PCM??? any thoughts or advise?? Sorry to say but it's probably the BCM (body control module) that's going in her car. The BCM controls everything inside your car, from the gauges, locks, ...
...lamp each time a window switch is pressed in either direction. If you get a good flicker in both directions from both switches, you can be sure that all the circuits down to the motor are good. You ...
...switch etc. I got my trusty voltmeter out. Testing the voltage on the light blue wires in my tail light connector I found the required +12Volts for the brake lights when the brake pedal was pressed. ...
...lamp if work the outlet is ok, the problem is DVD.2) test the power cord for open or break and replace3) test the main switch for dirty, dust, clean it, and test for open or defective and replace.4) ...
Question about DVD-L200 Player
...L200 now iv tried to wire them through a relay as normal but want them to work of the main beam switch on the dash in my wisdom iv tried to connect to there is a 6 volt feed but how do i wire to that ...
...rear compartment lamp. When the rear compartment is opened, its switch closes to provide a ground circuit and the rear compartment lamp illuminates. Ground is provided at G104. Is the switch struck
Lamp turned on. That light and the brake lights should be 21 watt bulbs. Or you have the wrong bulbs fitted? Or the light switch is faulty. Or the grounds at the back are bad, but they shouldn't be on
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions