Questions & Answers for: lamp code

Question about WD-52525 52" Rear Projection HDTV

2 Answers

...Test indicates code 34-lamp abnormality? I had another problem kinda the same and emailed ctechnicians.com and they gave the fix. is the fans runing at all ? if not the set will not come on at

Ad

Question about DS+60 Multimedia Projector

1 Answer

...code without being in boot mode 16 Invalid interrupt. Power off/on. If it persists, contact dealer/factory. 17 Forced boot mode. Keys held down too long. 18 Attempting to program boot mode without ...

Ad

...lamp. if it does not come on before the code occurs, then the lamp or thermal fuse is likely gone. if the lamp comes on then the code, the AE sensor is likely gone. Hope this is of some help. ...

Question about WD-62525 62" Rear Projection HDTV

1 Answer

Code Probable Cause 12 No error detected 22 Recovery from momentary Reset 32 Lamp Cover open 33 Air Filter Cover open 34 Lamp abnormality 35 Chassis Fan failure 36 Exhaust (Back Cover) or Lamp Ballast

...lamp problem? 34 code is common and indicates "lamp abnormality" If you are not clear on how to read the code I believe your owners manual has a section explaining that. If the lamp was blown it is ...

...The Lamp Code is located on the Left side of the set. It is a sticker labeled Lamp Code. Order a Lamp by this code. Replace the lamp in reverse order and reinstall the lamp Door with all four

...code? Please let me know and I can help Tim http://safemanuals.com/annexe_Reference%20Guide_INFOCUS_LP600-_E.htm the blink codes are in the manual Red LED Behavior Explanation One (1) blink The lamp ...

Question about WD-73827 73" HDTV DLP TV

1 Answer

Code Probable Cause 12 No error detected 22 Recovery from momentary Reset 32 Lamp Cover open 33 Air Filter Cover open 34 Lamp abnormality 35 Chassis Fan failure 36 Exhaust (Back Cover) or Lamp Ballast

code which indicates lamp issues: 66 A) Lamp did not turn on at P-ON sequence... Check CJ4 circuitry B) No Lamp Inserted............... No Lamp inserted C) Disconnected cable between ballast and lamp.

Question about WD-73827 73" HDTV DLP TV

1 Answer

...Code: F5-02 Description:Copy lamp lighting abnormality The copy lamp does not turn on. Causes:Copy lamp abnormality Copy lamp harness abnormality CCD PWB harness abnormality. Remedy:Use SIM 5-3 to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Cindy Wells

Level 3 Expert

6688 Answers

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

Are you a Televison & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...