Questions & Answers for: knox sensor

Question about 1991 S-10

1 Answer

...Knox sensor & or the Blue wire going to it if it is Grounded , the timing will not Advance, Knox sensor is there to detect knock then it grounds if it catches a Knock to Prevent Pre Ignition ...

Ad

...knox' sensor's need replacement @ I have been told 'knox' sensor's need replacement @ nearly $700...????? Upper part of motor needs to be taken off, etc..if I don't replace the sensor, could bend a ...

Ad

...knox sensor. I have changed all four coil packs and plugs due to previous faults and the car was ok for 3 weeks, I now have the above faults but the car runs very well, is this just due to rubbish ...

Question about 1996 Altima

1 Answer

replaceing the knox sensor where is the knox sensor located so I can check the connections? Do you mean knock sensor? well, it's located below intake manifold

Question about 1998 Villager

1 Answer

...it to fix the knox sensor, and where is it located? http://groups.yahoo.com/group/villagerquest/ do not ever change a knock sensor for any reason. they don't help or harm anything. just waste of ...

Question about 1994 Pickup

1 Answer

...Knox sensor. I replaced the knox sensor when I replaced the motor. Ive done all the basic checks i.e. plug wires, cap plugs, injectors signal good. Can the tps send a signal to disrupt the functin of ...

Question about 2004 Avalanche

1 Answer

...knox sensor. Hello: Approximately 2 - 4 hours depending on the ability and experience of the technician performing the task. There are two sensors, both should be replaced. The intake manifold has to ...

Question about 2004 Avalanche

1 Answer

...knox sensor HI, they are located under intake manifold. The first sensor is located in the front of the engine and the second sensor is located in the back of the engine. Remember to replace the ...

location of knox sensor on 96 outback legacy 2.5 1996 Subaru legacy outback with 2.5. Where is the knox sensor located Here you go John.see diagram below

I have a 94 f150 4.9liter 4.9liter inline 6 need location of Knox sensor The knock sensor seems to be right beside the distributor. Would appreciate a helpful rating if it solves your problem.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...