Questions & Answers for: Ford Ranger knocking valve

Question about 1994 Ranger Supercab

1 Answer

...knocking niose and start's to pour smoke. I replaced the valve pan gaskets and did not fix the problem. Any help would be appreciated. it happens when the motor shift's down you got head gasket ...

Ad

1987 2.3L knocks/after warm up/2500RPM/10 min operation My 1987 2.3L knocks after warm up at around 2500 RPM. I just redid a head gasket and am currently checking my valve lash becuase it is a ...

Ad

Question about 1984 Ranger

1 Answer

...v6 and i have a very loud lifter type knocking coming from the left valve cover area i have the same sound but I've been told that its a gasket leak from either in front or behind the exhaust ...

Question about 1998 Ranger SuperCab

2 Answers

location of the EGR valve/DPFE pressure sensor I have a 1998 Ford Ranger truck will it cause any problem if not fixed soon? What engine? It won't cause any running problem but gas milage will be ...

Question about 1995 Ranger Supercab

3 Answers

Octane Ping and running lean I have a 2.3 liter 1995 Ford Ranger that is having octane ping at 45 mph or greater even running high octane fuel, when speeds are less than 45 I can intentionally lug the

have replaced about all relays and sensors plugs and wires fuel pumps egr valve and solenoid eec relay tps sensor air charge sensor o2 sensor coolant sensor have in my hand knock sensor havent put in ...

Question about 1991 Ranger Supercab

1 Answer

spark knock i think under loads or up hills 91 ford ranger 4.0liter 5 speed manual. Your timing could be too far advanced, EGR valve could be stuck closed, engine could be getting too hot (antifreeze ...

Question about 2002 Ranger Regular Cab

1 Answer

...valve stuck open how do i fix this It controls the length and speed of incoming air for a certain engine rpm to optimize swirl, efficiency, and minimize knocking. Most likly you have a vacum leak ...

Question about 2003 Ranger Regular Cab

1 Answer

Code PO442 Replaced gas cap twice. Filled up afterwards. The first time worked out. Knocked out the code with no problem then. Got the code again. Repeated the same process, and still have the same ...

knocking A lifter problem can only be fixed by changing the lifter. You might as well change all of them because it is just as easy since you have already had to take the heads off to get at the noisy

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...