Question about KITCHEN AID 5 Quart Artisan Series Stand Mixer
...low causing the mixer attachments to hit the bottom of the bowl. This is causing the entire mixer jump, vibrate and shimmy til it almost falls off my counter top. I've tried to tighten up some of the ...
...mixer sit too low, which makes the head bump around a lot. How do I fix this? I've tightened all the screws I can see. This sounds like an issue of beater to bowl adjustment, which can come out of ...
Question about KHM5TB Classic Plus Hand Mixer
...mixer is attached, is dipping down too low When I mix things, the head goes so far down that the mixer part is hitting the bottom of the bowl and scraping it. HI. You may have asked your question in ...
mixer, model #KSM90PSWW, age unknown. The beater sits too low and rubs the bottom of the mixing bowl. Is there a way to fix this? JOE:You don?t say if you have a ?tilt-head?or a ?bowl-lift' mixer, but
Question about K5SS Heavy Duty Commercial Stand Mixer
...mixer (k5ss lift bowl?) smells as soon as I start using it. It makes an intermittent noise at lower speeds, best described as a groan or low pitch squeal. There is no noise at higher speeds. What ...
Question about KSM150PS Artisan Series Stand Mixer
...too low. The beaters are scraping the bowl. Just adjust the screw between the head and the stand (when the head is in upright position) clockwise. This will rise the head, so it won't scrape the
mixer is turnon at low speed. Once it starts to mix then it's ok. Firstly, I think you mean "flour". Put in your ingredients. Cover the mixer, head and bowl, with a dishtowel. Turn on mixer to "stir"
...down to low in the bowl Tip the mixer up and look for a screw on the hinge underneath the top part. Turn this screw counterclockwise about 2 turns and the paddle will clear the bototm of the
...mixer bowl as low as it can go with the screw but it is still not low enough Then you are using the wrong beater or bowl for the mixer. What model is it? Newer KA mixers are very part specific. Not ...
Question about K45SS Classic Stand Mixer
mixer KSM150 out of the box, head won't lock. Lever won't slide all the way to lock. Locks slightly but still has up and down play in down position and won't lock at all in tilted up position. All the
Usually answered in minutes!
493 Questions
357 Questions
324 Questions
285 Questions
205 Questions