Question about Bilt Tb70ss Gas Trimmer
...Still it will not start. Plug has fuel on it when removed and inspected. check to see that the kill button is not stuck in the contacting position, and if it is, try to get it unstuck. WD40 ...
Question about Bilt 5.5hp Self Propelled Mower
mower will not start....there is gas and oil in the mower i had the same problem and it was my kill switch on the left of the motor the cable hooks up to the plate was sticking so when you hold the ...
...two troybilt trimmers and neither sparks. TB 70 models. Could two coils be bad? I have removed the kill switches. I am using a drill to turn the drive spindle and test coils. I thought perhaps the ...
Question about Bilt 5.5hp Self Propelled Mower
I found a big mouse nest on top of the engine and now my mower runs for 30 seconds then stops. Do you think the heat damaged the valves? For you to have found a mouse nest on top of the engine, then ...
Question about Bilt 5.5hp Self Propelled Mower
I have a Troy Built 675 walk behind power mower (Briggs & Stratton 190cc) that tends to run for about 10 minutes then sputters and dies. I tried to switch the fuel but that did not help. It won't ...
MODEL TB70SS STARTS EASY, KILLS WHEN THROTTLE MODEL TB70SS STARTS EASY, KILLS WHEN YOU GIVE IT GAS, STALLS OUT IMMEDIATELY.. check your air filter. when you take the filter off see how it runs without
Question about Troy-Bilt 4-Cycle Curve Shaft Gas String Trimmer #41ADT41C966
...kill switch on the handle check out ok with a meter? I want u to make sure a critter hasn't built a nest in the exaust hole. Use something to get in there and scratch around with, and blow out with ...
...Shut Off One of two things will keep the engine from turning off. The most likely cause is a dirty kill switch. Pop the switch out with a small knife or screwdriver, disconnect the wire leads. Clean ...
lawnmower heats up pull of the top cover and see if the is grass or a nest built up under the covers
Question about Bilt 5.5hp Self Propelled Mower
WHERE IS THE KILL SWITCH ON A TROYBUILT SELF PROPELLED LAWNMOWER the switch is built right into the cover over the carb , there is a cable that runs right too it from operators handle
Usually answered in minutes!
623 Questions
420 Questions
215 Questions
193 Questions
129 Questions