Questions & Answers for: Craftsman kill nest

craftsmans31c707 16hp riding lawn hard to turn over wont start hard to turn over i had the same problem ,replaced the battery,and starter turned out the muffler was plugged with a wasp nest,also ended

lawn mower runs for 20 minites shut down and wont start till it cools off Remove the engine housing cover and check to see if some type of rodent has decided to build a nest. I have seen this a few ...

...kill switch out by removing the metal cover on the engine and removing the coil shorting wire. Crank it again and see if you have spark. Yes? You have a bad switch somewhere. It could be the ignition ...

...now when start runs fine till pull on pto for mower or take out of park to drive and it dies like kill switch~ check the "kill switch" they are usually located in the seating area.  it senses ...

craftsman push mower caught fire. while using the push mower, smoke then flames began coming from engine. We turned off the mower, put out the flames with water. my son wants to try repairing it but ...

runs good,but when the motor gets hot it cuts off for a while remove the upper cover from the engine and check for air flow mice like to build nests under the cover then it over heats

Craftsman with 190cc only idles Engine cranks and runs fine. But will only idle. remove the top cover from the engine and see if there is a nest stopping the governor linkage from moving

where is kill switch there is not a kill switch. It should be keyed.

As I was mowing I began to notice that my tractor losing power and couldn't make it up the slightest hill. Today it seems to have gotten worse and smells as if it is overheating. Look to see if a ...

What causes a Craftsman 24" Snow Thrower not to start. I replaced the sparkplug, changed the oil and used fresh gas. I tried to start it electronically and manually, but it won't turn over. If you ...