Questions & Answers for: Maytag keypad

...CODE IS LOCATED ON SERIAL PLATE ON THIS UNIT AFTER THE WORD CODE.-1. PRESS & HOLD THE DOOR ALARM KEYPAD.-2. PRESS & HOLD FREEZER TEMP DOWN KEYPAD.-3. RELEASE DOOR ALARM KEYPAD AND WAIT 3 ...

...are not working rendering the unit useless Hi and welcome to FixYa. I am Kelly. This is a keypad problem. Most keypads can be replaced. Some are all in one control panel and keypad units. ...

...doors need to be open to program? 1. Open the Fresh Food door and press and hold the Door Alarm keypad DoorAlarm . 2. Press and hold Refrigerator Temperature UP keypad . 3. Release the Door Alarm ...

Keypad don't light up Keypad don't light up see this causes and fix it. God bless youLights come on, but can not program unit, Touchpad dead If you have a stuck key or non-responsive key, ...

...breaker and wait then try again but oven will not heat again until it cools down. F2 - E0 Shorted keypad (also called touch pad) 1. Check keypad connector for firm connection (keypad connects to ...

...replaced the control board and now it won't reset Hi try this. 1 press & hold the door alarm keypad. .2 press & hold freezer temperature down keyboard within 3 seconds. .3 release the door ...

...on the Serial Plate on this unit after the word Code.

1. Press and hold the Door Alarm Keypad .

2. Press and hold Freezer Temperature Down Keypad .

3. Release the Door

...: Service Test Mode: The service test functions are performed using the refrigerator display and keypad. Enter the Service Test Mode by performing the following sequence of events. 1. Open the ...

...is flashing PEO OOO Program code is located on the serial plate Press and hold the Door Alarm keypad. Press and hold the Freezer Temperature Down keypad within 3 seconds. Release the door alarm ...

my maytag gemini oven keypad (numbers only) stopped working. the other buttons on the keypad still beep when pressed, but the numbers are dead. any suggestions? it just started this morning and i ...