Questions & Answers for: Yamaha TZR 250 key wont turn in ignition

turn over in my 1996 yamaha big bear Is there an ignition switch, or is there a problem with the starter itself? batteries dead or dosn't have enough volts.try taking a jumper box and hooking it up if

Ad

Question about 1990 TZR 250

2 Answers

setting Timberwolf 250 timing how do I set a 1992 Timberwolf 250's timing I think your bike has CDI ignition which means the ignition timing is fixed and cannot be changed. Are you having a problem of

Ad

wiring head lights to my 1988 blaster. but i made a new kill switch.so the high and low beems for the lights are not connected i just want a constant power to the lights when the blaster is started ...

...wont work until key is put in and turned to first position...have stripped ignition switch all seems ok check the other end of the ingnition wires to the key switch and from the key switch to the ...

Question about 1990 TZR 250

0 Answer

Not starting Hi. I was riding the bike and parked it in the garage.It was going fine but the next morning it was dead.Does not want to start. Hi, Shawnw662 before testing any electrical component in ...

Question about 1987 TZR 250

0 Answer

...wont run i dnt kno if it's the battery, starter,or if the pins are stuck Hi, Www_silasmus and the usual suspects are: 1. Fuel tank empty. 2. The fuel tank has old dead gas. 3. Fuel tank bottom ...

Question about 1990 TZR 250

1 Answer

...wont fire also has new spark plug any ideas cheers Paul Dirty contacts in the ignition switch contact base. You may not be able to disassemble and clean your switch but you can check the wires for ...

Question about 1990 TZR 250

0 Answer

...wont start.also checked reed valves they seem to be sealing ok. if you do get the bike to start it can rev very high for a short while then dies! what are the correct size for the two main jets? why ...

Question about 1990 TZR 250

0 Answer

my tzr 3ma wont rev over 7000 rpm my tzr 3ma starts and runs fine but it wont rev over 7000 rpm.were all the 3ma, s restricted at all. Hi, Kevin and the usual suspects are: 1. Severely drained or ...

Question about 1990 TZR 250

0 Answer

fix backfire at idle TZR 250 backfire at idle Hi, Anonymous and the usual suspects are: 1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...