Questions & Answers for: Chevrolet 1500 key wont turn in ignition

...wont ignite. Has small sputter, or releases gas sound at end. Any ideas. stand in driver door and turn the key on but not to the point of startup and listen for the fuel pump by the gas tank if you ...

wont even try. fuses are all good to go. Listen for a click from under the steering column when you turn the key on. If you hear no electrical click then your ignition switch could be bad. If you hear

wont start out of the blue changed icm,coil getting fuel no spark draws current at the coil when key is turned That old of a vehicle you might want to take the cap off and check to see if the shaft is

...key wont turn at all. I put the key in the ignition and it wont turn. Ive tried all my keys. the steering collum housing is off so i can work on it. Try turning the steering wheel I know it is locked ...

...wont start if I turn on the ignition. you might have a bad connection or bad wires bad ground the first thing you have to do is see if you are getting 12 volts to the thick red wire on the starter ...

wont start unless manually primed Turn the ignition key to the ON position without starting the engine You should hear the fuel pump priming for about a few seconds then shutting itself off. If not ...

key it wont continue to run more that a second or 2..just changed oil pressure switch.. new cap n rotor. Plugs n wires. Ignition module..still nothing..any help would be greatly appreciated thanks joe

wont start. lights stay bright, but there is no sound when I turn the key. can u please explain how to check to see if its my ignition switch? thank you. aaron fuentes check to see if its your starter

key unlocks the ignition lock cylinder but it wont turn far enough to get to the crank position, you may have a bad ignition switch. The switch is NOT the part near the steering wheel where you insert

...wont start with new starter/altenator/battery still get no turnover? Check your fuses, then move on to the ignition switch. It sounds like somewhere up the line there isn't a connection closing ...