Questions & Answers for: kenmore elite he4 gas dryer

...kenmore elite oasis quiet pak 2 gas dryer smells as if there were a fire in it!!!! and ironically, when i noticed the smell i also saw water around the base of the kenmore elite oasis top loading HE ...

...Kenmore Elite H3 GAS dryer I have extensively cleaned lint, this problem keeps coming back. It shuts off the dry after just a few minutes. What is this E1 Error code? and how to fix it? E1 error code ...

...thermal fuse I have a kenmore elite dryer and the heat does not work in any settings... Mdel 110 c60952990.. .Checked main breaker fuse and open dryer cleaned all the unwanted lint and still no ...

...Kenmore Elite HE4 Gas Dryer Dryer stopped heating up. Runs fine. No Errors posted . Gas to Dryer - checked.. Cleaned lint and verified good air flow.. hi..A poor connection between the wire terminals ...

Kenmore Elite Sensor Smart Gas Dryer - no hot air I have a Kenmore Elite Sensor Smart Gas Dryer - top loader - that is not blowing hot air. All of the buttons work and the cycles begin but the air ...

gas dryer. outside vent was plugged. burning smell from gas dryer. outside vent was plugged. think its cleaned but now want to check inside dryer for flamables. Need to check air path from lint screen

Kenmore Elite HE4 gas dryer will not start although all controls on front are lite and appear to be functioning properly (settings can be changed, etc). I has been working fine for several hours until

...Kenmore Elite gas dryer - model # 110 70052990. Just hooked it up after a year of not using it and it continues to shut itself off on Normal dry (begins at 40 minutes) and shuts off at 38 minutes. ...

kenmore elite he4 what's the model number?if it's gas you could have bad gas coils,the coils will work for the first 15 to 30 minutes and then no heat,when the coils are failing they will work

...gas dryer to clean out all lint are there additional clips or screws which are not visible?? I was having the same problem. I found the screws that lined each but I was over looking a screw almost ...