Questions & Answers for: InFocus keeps blowing lamp

...lamp exploded, check the vents for dust. there is a temp sensor that will shut down the projector if it gets too hot. if the vents are clogged, blow the dust out of the projector with canned air. the ...

keeps blowing. This is the 3rd one. My lamp blew out on my 4805. I bought a new one put it in and it lasted one day then blew out again. Replaced the lamp again. after one week it blew. It sounds like

...keeps on blowing only had it 3 years from new ,the last lamp that blew the red light flashes 3 times and on the other lamp flashes once. thanks brian This is because you have a bad lamp balast you ...

...lamp is off, you need to clean the dust out of your projector because it's overheating. dust keeps in the heat that the projector is trying to expell. blow it out with canned air. if it still does ...

...extend the life of the lamps. dust keeps in the heat that the projector is trying to expell. heat will kill the lamp and possibly overheat other circuits and components. use canned air to blow it

...keeps in the heat. this shortens the life of your lamp and projector. if you do need the colorwheel replaced, you could get the part from an infocus service center and do it yourself, or send it in ...

...lamp and blow the dust out of the projector. the dust keeps in the heat that the projector is trying to expel. the lamp probably overheated and shattered. otherwise, it was at the end of it's life ...

...lamp light indicator keeps coming on after 20 minutes or so. Current lamp life is only 51 hours at present. Should the lamp be replaced to orrect this matter? it may be overheating. blow the dust out ...

Hello I have the infocus screenplay 5000 projector & after reading all the posts here decided I dont have a similar problem to anyone else. My bulb life expiration came up months ago but the unit ...