Questions & Answers for: Quantum Fireball jumpers

...frieball plus AS 20.5 goes as follows:if having drive in hand power is to left, move right to jumpers ! Jumper config table on mine says, reading left to right now. far left no jumper PK is

old maxtor harddrive need to know jumper cofiguration Most Maxtor Drives have jumper setting so that if "Jumper 50" is set; the two pins farthest from the power jack, is Master Drive. No pin jumper ...

...my coputer and how do i set the jumper If I recall right this HDD is a PATA (IDE) type. As for the Jumpers please check the following link. The jumper should be as Slave drive.

...a boot up message stating "primary Hard drive 0 not found". In the Bios, it is listed as "unknown". Jumpers set on CS, but tried Master too...the maddening thing is that when I slave this HD to ...

...to be the slave drive, and you know what that you must change the current jumper settings. The four jumpers on the drive are labeled DS, CS, PK, and Rsvd. The description of the jumpers doesnt tell ...

How to set jumpers in an old quantum fireball Lct20 HD. The master mode needs to be "jumpered" Please look on top of your HD and u will see a table that show u the HD jumper setting (Master, Slave or ...

hard disk not recognized I connected my quantum fireball lct 20 hard disk to my computer. When turned on, it cannot detect the hard disk. Tried several position jumper configuration but still not ...

...do i configure this hard drive for a 'slave' ? You need to set the drive as a slave by moving the jumpers the the correct pins. You should see 4 sets of pins, for slave you put the jumper over the ...

...to be the slave drive, and you know what that you must change the current jumper settings. The four jumpers on the drive are labeled DS, CS, PK, and Rsvd. The description of the jumpers doesnt tell ...

what does the PK and RVSD on jumpers mean? Hello there, Jumper Parking (PK) Position The PK position is used as a holding place for the jumper for a slave drive in systems that do not support Cable ...