Questions & Answers for: Maxtor jumpers

...setting using only one jumper ( only eight pegs to place the jumper on) could it be that i need two jumpers? i googled it and a few sites showed examples of maxtor jumper settings but the pictures ...

...for a Maxtor harddrive. I want to make it a slave in another system. I just need to know where the jumpers need to be placed usualy its just one jumper if no jumper on maxtors becomes slave. jumper ...

jumper settings current backup hd has jumper on top/bottom of #1 pinm abd jumper from top of #2 to top of #3, had been working as backup to c: drive, I want to make it as master. Where can I find a ...

i need jumper settings for maxtor n256 model 96147h6 i wish to run it as a slave pls help. thx For use as slave there is no jumper connected. (Master on/slave off0 The jumper settings are listed on ...

5T020h2 jumper setup No jumper is used on the J50 pins, when using the Maxtor 5T020H2 IDE harddrive, as a Slave harddrive. In otherwords do not use a jumper on any of the jumper pins. This is a PDF ...

I want to add another hard drive and need to know how to set the jumpers on my maxtor 90645d3 please help.ty if you want to boot from this drive, please set the jumper to the master position. if this ...

jumper settings for slave drive model 33073u4 30 jumper settings for slave drive model 33073u4 30 gig hello go to this link.. it will illustrate jumper setting http://sysdoc.doors.ch/MAXTOR/diamondmax

...or Slave. If there is a CD drive on this cable too then the drives on this data cable then the jumpers on each drive must be set differently, they cannot be set the same jumper

What is the jumper pin placement to make a slave of a DiamondMax Plus 9, 80GB hard drive? The manual is linked below and section 3.3.1 covers jumper settings. The slave setting shows the park position

Jumpers Serttings on Quantum HD Where are the jumper pins and what are the slave settings. Only jumper I found has ..CS..DS..and SP. Right now the jumper is on the DS pins. Thanks! Nick CS = Cable ...