Questions & Answers for: E-Machines what is a jumper plug

...plug in there. Could it be possible that the Power Switch and Reset jumpers were plugged in here? Finally, there's a "INTR DR" jumper as well, next to the BIOS jumper. I hope you understand what I ...

...wrong? I appreciate any help. [email protected] Thanks see the hardrive cables and also check that jumpers in hard drive just connect one hard drive at a time first ok set jumpers to master settings ...

...one it goes on? if im not mistaken look at mother board and there should be a bunch of pins or jumpers towards the front of the case mine all line up in a ...

jumper cap from pins 1-2 (default) to pins 2-3 for about 5-10 seconds, then move the cap back to pins 1-2. Reinstall the battery. Plug the power cord and turn on the computer. Hold down the key during

...all lights are working but can not get a display on my monitor you can try to reset cmos.the cmos jumper is in most cases near the battery on the motherboard.or,if you dont know how to move the ...

jumper plug in this position for 30 sec. ( with power off and unplugged ) and then move jumper back to normal. You will then have to reset the time and date. Don't be afraid of taking the skin off the

...good clear, this is a little extreme but do it just to make sure. Move the jumper back to the normal operating position, reinstall the battery, plug it in, cross your fingers and try and boot from

...jumper back into it original position. Step 7: Plug your power cable back in and turn your computer on. Now you bios password should be reset. To enter the bios press the the F2 or Del key when your ...

jumper covers on the set of pins next to the power adapter plug. If the CD drive will be the only device on the IDE data ribbon cable, set the jumper cover on the two pins farthest away from the power

emachines front panel connections the system board should be labelled where the jumper pins connect. if you are in the right spot, but the lights dont work, then flip the connection around, because ...