Question about Barracuda 7200.10 500 GB SATA Hard Drive
...If I remember correctly then you nee to REMOVE the jumper to have it as a slave drive. Otherwise the second from left (with power plug on the right) is usually the SLAVE position on those ...
Question about Barracuda 7200.9 (ST3250824A) 250 GB Hard Drive
...check either on the sticker or on the plastic around the jumper. move the jumper to the appropriate spot then plug the enclosure into the computer and the wall if it needs power. hope this
Question about ST3200822AS 200 GB Hard Drive
...plug as a reference for how the jumper fits on the pins to make the drive "cable select" and what that means is the drive will conform to which cable is plugged into it. If you have the slave cable ...
Question about Notebook Hard Drives: 40GB (ST94011A) 9.5mm 5400RPM 2MB Notebook Hard Drive (DMST94011A)
...you can try setting the jumpers to master mode, check the sides of the hdd, it has a jumper setting and set it to master, using the shorting pin, just plug it out and connect it to the right ...
...lead before removing anything then place the new hard drive in rembering to look at the plastic jumper and its location plug the electical & IDE/SATA lead in restart your computer hope this ...
...Are there any special jumper settings to make this serial attached ATA (SATA) so that is not recognized as a master ? re: ST9160821AS Thanks, Tommy No just plug it in to the extra plug on the
...plug and then removing a battery for 30 minutes from the motherboard. Another way is to reset the clear CMOS jumper on the motherboard itself. Both of the 2 methods mentioned works because most ...
...jumper to Slave. If it is SATA, interface, You cannot "SLAVE" a SATA drive. All SATA controllers are stand alone. You just plug it into the Sata slot available & power cable to the HDD. Be sure ...
...plug drives into USB ports the drive needs to be set for mast not slave. The internal drive is one one channel and external drive is on a different channel so neither drive is a slave, both are ...
What are the correct jumper settings for my hard drive in an e-machine T-6520 with windows home ed. XP2005 cooperbill78 these are the jumper settings for a Seagate Barracuda ATA harddrive, ...
Usually answered in minutes!
600 Questions
303 Questions
161 Questions
116 Questions
84 Questions