...turn off the machine - remove power plug - place jumper on J50 (it's a 2 pin jumper) for about 10 seconds - remove jumper you put on J50 - plug back in - turn power on and press F2...have a nice ...
...the jumper (called J1) is located next to the plug for the status panel LCD. Briefly place on pins 1-2 about 10 seconds, then replace to pins 2-3. That's all, except closing up the machine
...plug in your system. Your reset is now complete 2. Some motherboards have a 3 pin jumper by the battery. Lets say that the jumper is on pins 2 and 3. Remove the jumper while the machine is OFF and ...
...plug in your system. Your reset is now complete 2. Some motherboards have a 3 pin jumper by the battery. Lets say that the jumper is on pins 2 and 3. Remove the jumper while the machine is OFF and ...
jumper. If it was present before, and sitting on just one pin, put it back. 5) Plug the computer back into power. WAIT 1 minute, turn the computer on. For additional questions please post in a Comment
...a fact you may be interested in ]First see if the Power Supply will turn on. This is done with a jumper wire, on the Soft Power On wire, in the ATX main power cable's connector.Your ATX main ...
...code ? i lost my bios password remove the bios password by removing the cmos battery, removing the jumper from the pins right next to the battery, marked something like pswd, plugging it in and ...
Usually answered in minutes!
242 Questions
91 Questions
72 Questions
52 Questions
