Questions & Answers for: E-Machines what is a jumper plug

...plug in there. Could it be possible that the Power Switch and Reset jumpers were plugged in here? Finally, there's a "INTR DR" jumper as well, next to the BIOS jumper. I hope you understand what I ...

Ad

Question about EMA IMPERIAL GV (845GV) TG3 eMachines (145119) Motherboard

1 Answer

... but still no signal. The mother board is a 143159 Imperial_GV 20030812. Trying to find the manual. jumper settings for old graphic needs to be disabled or in the bios settings the on board vga ...

Ad

Might have messed up jumpers on t2824 motherboard I was adding a second hard drive and vaccumed the motherboard to get some dust off it. Now I get the green light on the motherboard but it won't power

...and installed as USB PnP device. Is the drive dying? Am I doing something wrong? Try changing the jumper settings to make it the Master instead of the slave drive Check the jumper on the drive. It ...

Question about T2893 PC Desktop

1 Answer

jumper cap from pins 1-2 (default) to pins 2-3 for about 5-10 seconds, then move the cap back to pins 1-2. Reinstall the battery. Plug the power cord and turn on the computer. Hold down the key during

...jumper over one post/pin unplug it from the 2pins on the right then plug it into the 2pins on the left plug it back up then hit the power button on the pc like you would to boot it and wait for a few ...

...HDD slot, clip/screw it in. 2. plug in data and power cables for new HDD 3. set main HDD jumper to master 4. set new HDD jumper to slave (middle pins) NOTE: make sure you wear a grounded wrist ...

Question about etower 667ir PC Desktop

1 Answer

...jumper wire is contacting the metal terminal. I then plug the computer into power, and insert the other end down into ANY Black wire socket hole. It is just a brief touch. No more than 2 seconds. You ...

jumper covers on the set of pins next to the power adapter plug. If the CD drive will be the only device on the IDE data ribbon cable, set the jumper cover on the two pins farthest away from the power

Question about eMachines Desktop PC

1 Answer

...put the jumper back on pins 1 and 2. Plug the PC power cord up and start the machine. Laptops do not have this. Also note: Cmos is NOT the Bios. Hope this helps good luck and be careful in the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top E-Machines Computer and Internet Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Brad Brown

Level 3 Expert

19187 Answers

Andrew Chrostek
Andrew Chrostek

Level 1 Expert

187 Answers

Are you an E-Machines Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...